![how to flash cleanflight firmware how to flash cleanflight firmware](https://i.ytimg.com/vi/Gh-KxmzFiqA/maxresdefault.jpg)
Then soldered these cables to the power distribution board. Next step was cutting the power cables from the ESC, so these can fit on the bottom plate. Took the bottom center plate and mounted the power distribution board with on it. I also removed the 5V and GND cables from 3 ESCs and left only the signal cable (I was going to use the supplied BEC on the fourth one). Then unsoldered the original motor cables from every ESC. Next I mounted the MN2206 motors on the arms and cut the 2mm gold connectors as I was going to solder the motor cables directly to the ESCs.
#How to flash cleanflight firmware install
Thanks to Bill, who told me about the video and to FranzArians for sharing his way to install the firmware!įirst I mounted the M3 6mm nylon spacers on the top center plate. If for some reason you want to go back to the OpenPilot firmware, go to this page and follow the exact instructions “How to Upgrade the Bootloader and Erase Settings”. Then you can connect it to the Cleanflight Configurator. Important: To use the board through the UBS-Port, you need to power it with external battery. That’s it, now you have the Cleanflight firmware on your CC3D board. Check the “I know what I’m doing!” box and then “Flash” button. Now you can open the downloaded cleanflight_CC3D.bin. Open the OpenPilot GCS software, connect the CC3D board through the USB-Port, go to the “Firmware”-Tab and click the “Halt” button. Download the “ cleanflight_CC3D.bin” from GitHub. Install the Cleanflight Configurator from the Chrome Web Store and download the latest Cleanflight firmware for the CC3D board.
![how to flash cleanflight firmware how to flash cleanflight firmware](https://ftforumx2.s3.amazonaws.com/2018/07/188042_516d8876020b6c72e1101375e0683d2e.jpg)
Download it from the official ST-webpage and install it. We also need the STM32 Virtual Com Port driver.
#How to flash cleanflight firmware how to
Here is a manual how to install it, if you have some problems with that.
![how to flash cleanflight firmware how to flash cleanflight firmware](https://www.dronetrest.com/uploads/db5290/704/a2b9117da0124c93.jpg)
I have tried it yesterday and will show you, how to do this if you don’t want to watch the video.įirst download the OpenPilot GCS 15.02.02 (the newest 15.05 does not support the CC3D board) and install it on your computer. I used my Arduino Nano as FTDI adapter to do this, but Bill posted a video in the comments, how the board can be flashed only through the USB-Port. In one of my previous post, I described how to flash the Cleanflight firmware on the CC3D flight controller and why I prefer the CC3D over Naze32 at the moment.